Engine Coolant Temperature (ECT) Sensor: Installation

WARNING: This page is about a different car, the 2003 Suzuki XL-7, 2003 Suzuki Vitara, 2003 Suzuki Grand Vitara, and 2003 Suzuki Aerio. However, it is still accessible from the selected car via links, so may be relevant.

Reverse removal procedure noting the following: Clean mating surfaces of sensor and water outlet pipe. Tighten ECT sensor (1) to specified torque. See Fig 1 and TORQUE SPECIFICATIONS table. Connect connector to sensor securely. Refill cooling system.

Fig 1: Removing & Installing Engine Coolant Temperature Sensor

Courtesy of SUZUKI OF AMERICA CORP.

Reverse removal procedure noting the following:
- Clean mating surfaces of sensor and intake manifold.
- Check "O" ring for damage and replace if necessary.
- Tighten ECT sensor to specified torque. See TORQUE SPECIFICATIONS .
- Connect coupler to sensor securely.
- Refill cooling system.

Fig 1: Removing & Installing Engine Coolant Temperature (ECT) Sensor

Courtesy of SUZUKI OF AMERICA CORP.

Reverse removal procedure noting the followings:
- Clean mating surfaces of sensor and water outlet cap (2). See Fig 1 .
- Use new "O" ring.
- Tighten ECT sensor to specified torque. See TORQUE SPECIFICATIONS .
- Connect coupler to sensor securely.
- Refill cooling system.

Fig 1: Removing & Installing ECT Sensor

Courtesy of SUZUKI OF AMERICA CORP.