Removal & Installation (Lancer)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 Mitsubishi Outlander, 2003 Mitsubishi Montero Sport, 2003 Mitsubishi Montero, 2003 Mitsubishi Lancer, and 2003 Mitsubishi Galant. However, it is still accessible from the selected car via links, so may be relevant.
Throttle Position (TP) sensor is located on throttle body. Disconnect TP sensor electrical connector. Remove TP sensor screws and TP sensor. See Figure or Figure . To install reverse removal procedure. Install throttle position sensor so it is positioned as shown. See Figure. Turn throttle position sensor 90 degrees clockwise to set it. Tighten fasteners to specification. See TORQUE SPECIFICATIONS . Adjust TP sensor. See ON-VEHICLE ADJUSTMENTS article.