LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Air Bag Restraint Systems) >> Diagnostic Tests >> DTC B1022: Driver Air Bag Circuit Resistance Low >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2002 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.
  1. If air bag diagnostic system check has been performed, go to next step. If air bag diagnostic system check has not been performed, go to AIR BAG DIAGNOSTIC SYSTEM CHECK .
  2. Turn ignition switch to OFF position. Disconnect driver-side air bag connector at base of steering column. See Figure. Install Driver/Passenger Air Bag Load Tool (09932-75010) to harness connector. Turn ignition switch to ON position. Recheck DTC's. If DTC B1022 is displayed, go to next step. If DTC B1022 is not displayed, go to step  4.
  3. Turn ignition switch to OFF position. Disconnect SDM connector. See Figure. Measure resistance between SDM connector terminals No. 11 and 12. See Figure. If resistance is 1.2 ohms or more, replace SDM. See SENSING & DIAGNOSTIC MODULE (SDM)  under REMOVAL & INSTALLATION. Go to step  5. If resistance is less than 1.2 ohms, a short exists between Green and Green/Red wires. Replace wiring harness. Go to step  5.
  4. Turn ignition switch to OFF position. Disconnect driver/passenger air bag load tool from harness connector. Reconnect driver-side air bag connector at base of steering column. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect driver/passenger air bag load tool contact coil connector at steering wheel. Turn ignition switch to ON position. Recheck DTC's. If DTC B1022 is displayed, replace contact coil assembly. See CONTACT COIL & COMBINATION SWITCH  under REMOVAL & INSTALLATION. Go to next step. If DTC B1022 is not displayed, replace driver-side air bag. Go to next step.
  5. Reconnect all air bag system components. Using scan tool, clear all DTC's. Go to AIR BAG DIAGNOSTIC SYSTEM CHECK .
scientia non olet · About LEMON Manuals