Clutch Fluid Pipe and Hose Removal and Installation: Removal

WARNING: This page is about a different car, the 2004 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not allow fluid to get on painted surface.

Remove dust and dirt from each joint of hose (2) and pipe (1) to be disconnected and clean around reservoir cap.
Take out fluid with syringe or such.
Disconnect fluid pipe (1) from hose (2).

NOTE: To disconnect pipe (1) from hose (2), separate them by using flare nut wrench (4) and spanner (3) so as not to kink them.

Fig 1: Removing And Installing View Of Clutch Fluid Pipe And Hose

Courtesy of SUZUKI OF AMERICA CORP.