"4WD LOW" Switch Inspection
WARNING: This page is about a different car, the 2004 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative cable at battery.
- Disconnect "4WD LOW" switch coupler (2).
- Check continuity between "4WD LOW" switch terminals. If not, replace "4WD LOW" switch.
"4WD LOW" switch specification
Transfer lever "4L" position: Continuity
Transfer lever "4H", "2H" position: No continuity
- Connect "4WD LOW" switch coupler and battery negative cable.