Diagnostic Trouble Codes Confirmation Procedure
WARNING: This page is about a different car, the 2004 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
- Connect scan tool to DLC with ignition switch OFF.
- Clear DTC, pending DTC and freeze frame data in PCM memory by using scan tool.
- Start engine, warm it up to normal operating temperature and shift transfer lever to "2H" or "4H" range.
- Shift selector lever in "D" range and keep it there for 10 seconds.
- Increase vehicle speed to about 80 km/h (50 mph) in 4th gear and in "D" range.
- Keep driving at above speed for 20 seconds.
- Release accelerator pedal, decrease vehicle speed and stop vehicle.
- Check pending DTC and DTC by using scan tool.