Rear Brake Hose / Pipe Removal and Installation: Installation
WARNING: This page is about a different car, the 2004 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.
Reverse removal procedure for brake hose or pipe installation procedure.
- Be sure to obtain more than 3 mm (0.118 in.) clearance between axle housing and brake pipe.
- Install clamps properly referring to the figure and tighten bolts.
- When installing hose, make sure that it has no twist or kink.
- Fill and maintain brake fluid level in reservoir. Bleed brake system.
- Perform brake test and check each installed part for fluid leakage.