Master Cylinder Reservoir Removal and Installation: Removal

WARNING: This page is about a different car, the 2004 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect reservoir lead wire at coupler.
Clean outside of reservoir (1).
Take out fluid with syringe or such.
Remove reservoir connector pin by using special tool or remove connector screw.
Special tool

(A): 09922-85811

Fig 1: Removing Reservoir Connector Pin Using Special Tool
Courtesy of SUZUKI OF AMERICA CORP.
Remove reservoir (1).

NOTE: Do not allow brake fluid to get on painted surfaces.

Fig 2: Removing Master Cylinder Reservoir

Courtesy of SUZUKI OF AMERICA CORP.