Cooling Water Pipes or Hoses Removal and Installation: Removal

WARNING: This page is about a different car, the 2004 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative cable at battery.
Drain coolant.
Remove radiator inlet hose (1), outlet hose (2) and radiator outlet pipe (3).

Fig 1: Removing Radiator Inlet Hose, Outlet Hose And Radiator Outlet Pipe
Courtesy of SUZUKI OF AMERICA CORP.
Remove throttle body and intake manifold. Refer to THROTTLE BODY AND INTAKE MANIFOLD REMOVAL .
Disconnect ECT sensor (4) coupler.
Disconnect heater inlet hose (5) from water outlet cap (3).

Fig 2: Disconnecting Heater Inlet Hose From Water Outlet Cap
Courtesy of SUZUKI OF AMERICA CORP.
Remove water outlet cap (3) from cylinder heads.
Remove water outlet pipe (2) from thermostat case (1).
Remove thermostat case (1) from cylinder block.

Fig 3: Removing Thermostat Case And Water Outlet Pipe
Courtesy of SUZUKI OF AMERICA CORP.