<< E >> Flange Bolt Removal

WARNING: This page is about a different car, the 2003 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

Remove the plug on the side of the cylinder block.
Insert a Phillips screwdriver [shank diameter 8 mm (0.3 inch)] into the plug hole to lock the counterbalance shaft.

Fig 1: Inserting Screwdriver Into Plug Hole To Lock Counterbalance Shaft
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Loosen the flange bolt.

Fig 2: Loosening Flange Bolt
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.