LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Overhaul) >> Exhaust Manifold >> Removal And Installation >> Installation Service Point >> >> A << Water Outlet Fitting Installation

>> A << Water Outlet Fitting Installation

WARNING: This page is about a different car, the 2003 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a 3 mm (0.1 inch) diameter bead of sealant. (MITSUBISHI Genuine Part number MD970389) to the groove as shown in the illustration.
    Fig 1: Applying Sealant To Water Outlet Fitting
    G01867889Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Install the housing quickly (within 15 minutes) while the sealant is wet and tighten the bolts to the specified torque.
    1. Tightening torque: 13 +/- 2 N.m (113 +/- 17 in-lb)
      NOTE: After installation, keep the sealed area away from the coolant for approximately one hour.
scientia non olet · About LEMON Manuals