LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Overhaul) >> Crankshaft And Cylinder Block >> Removal And Installation >> Installation Service Points >> >> E << Sealant Application To Oil Seal Case

>> E << Sealant Application To Oil Seal Case

WARNING: This page is about a different car, the 2003 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply sealant MITSUBISHI Genuine Part number MD970389 or equivalent to the gasket surface of oil seal case.
    NOTE: Be sure to install the case quickly while the sealant is wet (within 15 minutes).
    Fig 1: Identifying Sealant Application Gasket Surface Of Oil Seal Case
    G01868002Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Apply engine oil to the oil seal lip, and then install the oil seal case onto the cylinder block.
    NOTE: After installation, keep the sealed area away from the oil for approximately one hour.
scientia non olet · About LEMON Manuals