LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (On-Vehicle Service) >> Timing Belt >> Inspection >> Balancer Timing Belt Tension Check >> When measuring the belt deflection

When measuring the belt deflection

WARNING: This page is about a different car, the 2003 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a pressure of approximately 100N (22 pounds) at the center (arrow area) between the sprocket as shown then inspect whether the deflection is within the standard value.
    1. Standard value: 5 - 10 mm (0.20 - 0.39 inch) 
    Fig 1: Applying Pressure Of Approximately 100N At Center Between Sprocket
    G01867828Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. If not within the standard value, adjust the belt tension. (Refer to TIMING BELT .)
scientia non olet · About LEMON Manuals