Rear Differential Construction
WARNING: This page is about a different car, the 2003 Suzuki Vitara, 2002 Suzuki Vitara, 2001 Suzuki Vitara, 2000 Suzuki Vitara, and 1999 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.
The differential assembly using a hypoid bevel pinion and gear is installed to the rear axle. It is set in the conventional type axle housing.
The reduction ratio is different among several kinds of engines or transmissions.
The differential assembly is decisive in that the drive power is concentrated there. Therefore, use of genuine parts and specified torque is compulsory. Further, because of sliding tooth meshing with high pressure between bevel pinion and gear, it is mandatory to lubricate them by hypoid gear oil.