1st Timing Chain & Chain Tensioner Removal

WARNING: This page is about a different car, the 2004 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative cable at battery.
Drain engine oil.
Drain coolant referring to COOLANT DRAINING .
Remove timing chain cover. Refer to TIMING CHAIN COVER REMOVAL & INSTALLATION .
For reinstallation of timing chain, align 8 timing marks as shown in the figure by turning crankshaft.

Fig 1: Identifying Timing Chain Marks
Courtesy of SUZUKI OF AMERICA CORP.
Remove LH bank 2nd timing chain. Refer to LH (NO. 1) BANK 2ND TIMING CHAIN & CHAIN TENSIONER REMOVAL .
Remove the following parts referring to 1ST TIMING CHAIN & CHAIN TENSIONER COMPONENTS .
- Timing chain guide No. 1 and No. 2.
- Timing chain tensioner.
- Timing chain tensioner adjuster.
- Idler sprocket No. 1 and 1st timing chain.
- Idler sprocket No. 2 and sprocket shaft.
Remove RH bank 1st timing chain intake camshaft sprocket bolt. To remove it, fit a spanner to hexagonal part (3) at the center of camshaft (2) to hold it stationary.
Remove RH bank 1st timing chain intake camshaft sprocket (1).

Fig 2: Remove RH Bank 1st Timing Chain Intake Camshaft Sprocket & Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Remove 1st timing chain crankshaft sprocket.