Clutch Master Cylinder Removal & Installation: Removal

WARNING: This page is about a different car, the 2003 Suzuki Vitara. However, it is still accessible from the selected car via links, so may be relevant.

Clean around reservoir cap and take out fluid with syringe or such.
Remove clip (6) and push rod clevis pin (5).
Disconnect fluid pipe (2) from master cylinder assembly (1).
NOTE: Do not allow fluid to get on painted surfaces.
Remove master cylinder attaching nut (3) and bolt (4).
Remove master cylinder assembly (1) and gasket.

Fig 1: Identifying Master Cylinder Assembly & Peripheral Components (Removing)
Courtesy of SUZUKI OF AMERICA CORP.