P0128 Confirmation Procedure
WARNING: This page is about a different car, the 2004 Suzuki XL-7 and 2004 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Intake air temp.: -8°C (18° F) or higher
- Engine coolant temp.: -8-80°C (18-176°F)
- Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg (75 kPa) or more)
- Connect scan tool to DLC with ignition switch turned OFF.
- Turn ON ignition switch and clear DTC, pending DTC and freeze frame data by using scan tool and start engine.
- Increase vehicle speed to 80-100 km/h (50-60 mph).
- Keep driving above vehicle speed for 20 min. or more (or until engine coolant temperature reaches 80°C (176°F)) (Change of vehicle speed is permitted in this step).
- Stop vehicle.
- Check DTC and pending DTC by using scan tool.