Rear-End Door / Rear-End Gate Lock Assembly Removal And Installation: Installation
WARNING: This page is about a different car, the 2004 Suzuki XL-7, 2004 Suzuki Grand Vitara, 2003 Suzuki XL-7, and 2003 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.
Reverse removal procedure to install rear-end door lock assembly noting the following points.
- Rear-end door / rear-end gate latch striker so that its center aligns with the center of groove in rear-end door / rear-end gate latch base. To adjust rear-end door / rear-end gate latch and striker with each other, insert proper number of shims (1) below the bottom of striker, as shown.
- Rear-end door / rear-end gate rubber cushion.
Move rubber cushion (1) installed at the left side of rear-end door / rear-end gate to align it with its guide.