Removal & Installation (3.2L & 3.5L)
WARNING: This page is about a different car, the 2002 Isuzu Trooper, 2002 Isuzu Rodeo Sport, 2002 Isuzu Rodeo, 2002 Isuzu Axiom, and 2002 Honda Passport. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Remove CKP sensor 3-pin harness connector. CKP sensor is located on right side of block, behind motor mount. See Fig 1.
- Remove CKP sensor mounting bolt and sensor. Before installing new CKP sensor, inspect "O" ring for damaged or wear, and replace if necessary.
- To install, lubricate "O" ring with engine oil and reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS .