Removal & Installation (2.2L)
WARNING: This page is about a different car, the 2002 Isuzu Trooper, 2002 Isuzu Rodeo Sport, 2002 Isuzu Rodeo, 2002 Isuzu Axiom, and 2002 Honda Passport. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
PCM must re-learn crankshaft position when CKP sensor is replaced. See TOOTH ERROR CORRECTION LEARN PROCEDURE
in SELF-DIAGNOSTICS - RODEO & RODEO SPORT 2.2L article.
Disconnect negative battery cable. Remove accessory drive belt. Remove power steering pump and mounting bracket. Disconnect CKP sensor harness connector. See Fig 1. Remove CKP sensor mounting bolt. Remove CKP sensor. To install, reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS .