Removal & Installation (3.5L)
WARNING: This page is about a different car, the 2002 Isuzu Trooper, 2002 Isuzu Rodeo Sport, 2002 Isuzu Rodeo, 2002 Isuzu Axiom, and 2002 Honda Passport. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Remove engine cover. Remove upper intake manifold. See INTAKE MANIFOLD (3.2L & 3.5L) . Remove CMP sensor harness connector. Remove sensor mounting bolt and CMP sensor from left cylinder head.
- Before installing CMP sensor, inspect "O" ring for damage or wear and replace if necessary.
- To install, lubricate "O" ring with engine oil and reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS .