Removal & Installation (2.2L)
WARNING: This page is about a different car, the 2002 Isuzu Trooper, 2002 Isuzu Rodeo Sport, 2002 Isuzu Rodeo, 2002 Isuzu Axiom, and 2002 Honda Passport. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect EVAP purge solenoid harness connector. Purge solenoid is located between ignition coil and cylinder head. Disconnect purge solenoid vacuum hoses. Remove 3 ignition coil bracket bolts. See Fig 1. Remove ignition coil bracket along with EVAP purge solenoid. Insert small flat-bladed tool into catch holding purge solenoid to coil bracket. Remove purge solenoid from bracket. To install, reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS .