LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Air Bag Restraint Systems) >> Diagnostic Tests >> DTC B1024: Driver-Side Air Bag Circuit Short To Ground >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2004 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure ignition is off. Disconnect lower contact coil connector, located at base of steering column. Connect BASE OF COLUMN connector of Load Tool (09932-75010) to harness side of lower contact coil using Load Tool Adapter (09932-78340). Turn ignition on. Using scan tool, retrieve DTCs. If DTC B1024 is current, go to next step. If DTC B1024 is not current, go to step  3.
  2. Turn ignition off. Disconnect load tool. Disconnect SDM connector. See SENSING & DIAGNOSTIC MODULE (SDM)  under REMOVAL & INSTALLATION. Measure resistance between ground and SDM connector terminal No. 9 (Green wire) and No. 10 (Green/Red wire). See Figure. If resistance is infinite, substitute a known-good SDM and retest system. If resistance is zero ohms, repair short to ground in Green wire or Green/Red wire. See WIRE REPAIR .
  3. Disconnect load tool and reconnect lower contact coil connector. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect STEERING WHEEL connector of load tool to upper contact coil connector using Load Tool Adapter (09932-78310). Turn ignition on. Using scan tool, retrieve DTCs. If DTC B1024 is current, replace contact coil. See CONTACT COIL & COMBINATION SWITCH  under REMOVAL & INSTALLATION. If DTC B1024 is not current, replace driver-side air bag module.
  4. Reconnect all components. Using scan tool, clear DTCs. Go to AIR BAG DIAGNOSTIC SYSTEM CHECK  under DIAGNOSTICS.
scientia non olet · About LEMON Manuals