LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Air Bag Restraint Systems) >> Diagnostic Tests >> DTC B1016: Passenger-Side Air Bag Circuit Resistance Low >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2004 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull top of glove box outward while depressing stops. Allow glove box to fall toward passenger seat. Disengage Connector Position Assurance (CPA) clip and disconnect passenger-side air bag module connector. See Figure.
  2. Connect STEERING WHEEL connector of Load Tool (09932-75010) to harness side of passenger-side air bag module connector using Load Tool Adapter (09932-78340). Turn ignition on. Using scan tool, retrieve DTCs. If DTC B1016 is current, go to next step. If DTC B1016 is not current, replace passenger-side air bag module. See PASSENGER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION.
  3. Turn ignition off. Disconnect SDM connector. See SENSING & DIAGNOSTIC MODULE (SDM)  under REMOVAL & INSTALLATION. Measure resistance between SDM connector terminal No. 7 (Yellow/Red wire) and No. 8 (Yellow wire). See Figure. If resistance is 1.4 ohms or more, substitute a known-good SDM and retest system. If resistance is less than 1.4 ohms, repair short between Yellow/Red and Yellow wires. See WIRE REPAIR . Reconnect all components. Clear DTCs. Go to AIR BAG DIAGNOSTIC SYSTEM CHECK  under DIAGNOSTICS.
scientia non olet · About LEMON Manuals