Contact Coil & Combination Switch: Removal
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disconnect negative battery cable. Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Contact coil and combination switch are located under steering wheel in steering column.
- Disconnect negative battery cable. Remove steering wheel. See STEERING WHEEL under REMOVAL & INSTALLATION. Remove hole cover and knee bolster panel. Remove screws and upper and lower steering column trim covers. Loosen clamp, remove band binding steering column and harness for contact coil and combination switch assembly.
- Disconnect contact coil and combination switch connectors. Remove contact coil and combination switch assembly from steering column.NOTE: New contact coil and combination switch assembly is supplied with contact coil set and held at center position with a lock pin and seal. Remove lock pin after installing contact coil and combination switch assembly to steering column.