LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostic Tests >> DTC B1047: Passenger-Side Seat Belt PRETENSIONER Circuit Short To Ground >> Diagnostic Procedure

Diagnostic Procedure

  1. Ensure ignition is off. Remove right kick panel and disconnect Yellow seat belt pretensioner connector. Connect STEERING WHEEL connector of Load Tool (09932-75010) to harness side of pretensioner connector. Turn ignition on. Retrieve DTCs. If DTC B1047 is current, go to next step. If DTC B1047 is not current, replace seat belt pretensioner. See SEAT BELT PRETENSIONERS  under REMOVAL & INSTALLATION.
  2. Turn ignition off. Disconnect load tool. Disconnect SDM connector. See SENSING & DIAGNOSTIC MODULE (SDM)  under REMOVAL & INSTALLATION. Measure resistance between ground and SDM connector terminals No. 6 (Light Green wire). See Figure. If resistance is infinite (open circuit), substitute a known-good SDM and retest. If resistance is not infinite, repair short to ground in Light Green wire. Reconnect all components. Clear DTCs. See DIAGNOSTICS . Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK .
scientia non olet · About LEMON Manuals