LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostic Tests >> DTC B1024: Driver-Side Air Bag Circuit Short To Ground >> Diagnostic Procedure

Diagnostic Procedure

  1. Ensure ignition is off. Disconnect lower contact coil connector located at base of steering column. Connect BASE OF COLUMN connector of Load Tool (09932-75010) to harness side of lower contact coil. Turn ignition on. Retrieve DTCs. If DTC B1024 is current, go to next step. If DTC B1024 is not current, go to step  3.
  2. Turn ignition off. Disconnect load tool. Disconnect SDM connector. See SENSING & DIAGNOSTIC MODULE (SDM)  under REMOVAL & INSTALLATION. Measure resistance between ground and SDM connector terminals No. 9 (Green wire) and No. 10 (Green-Red wire). See Figure. If resistance is infinite (open circuit), substitute a known-good SDM and retest. If resistance is zero ohms (short circuit), repair short to ground in Green wire or Green-Red wire.
  3. Disconnect load tool and reconnect lower contact coil connector. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect STEERING WHEEL connector of load tool to upper contact coil connector (in place of air bag module). Turn ignition on. Retrieve DTCs. If DTC B1024 is current, replace contact coil. See CONTACT COIL & COMBINATION SWITCH  under REMOVAL & INSTALLATION. If DTC B1024 is not current, replace driver-side air bag module.
  4. Reconnect all components. Clear DTCs. See DIAGNOSTICS . Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK .
scientia non olet · About LEMON Manuals