LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostic Tests >> DTC B1015: Passenger-Side Air Bag Circuit Resistance High >> Diagnostic Procedure

Diagnostic Procedure

  1. Pull top of glove box outward while depressing stops. Allow glove box to fall toward passenger seat. Disengage CPA clip and disconnect Yellow connector for passenger-side air bag module. See Figure.
  2. Connect STEERING WHEEL connector of Load Tool (09932-75010) to harness side of passenger-side air bag module connector. Turn ignition on. Retrieve DTCs. If DTC B1015 is current, go to next step. If DTC B1015 is not current, replace passenger-side air bag module. See PASSENGER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION.
  3. Turn ignition off. Disconnect SDM connector. See SENSING & DIAGNOSTIC MODULE (SDM)  under REMOVAL & INSTALLATION. Measure resistance between SDM connector terminals No. 7 (Yellow-Red wire) and No. 8 (Yellow wire). See Figure. If resistance is 4.5 ohms or less, substitute a known-good SDM and retest. If resistance is more than 4.5 ohms, repair open or high resistance in Yellow-Red wire or Yellow wire. Reconnect all components. Clear DTCs. See DIAGNOSTICS . Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK .
scientia non olet · About LEMON Manuals