Activating Air Bag System (3.2TL)
NOTE:
To reconnect front SRS connector, push sleeve-side connector half toward pawl-side connector half without touching sleeve. As connector halves are pressed together, pawl will push sleeve back. When connector halves are completely connected, pawl will release spring-loaded sleeve and lock connector.
- Ensure ignition is OFF and negative battery cable is disconnected for 3 MINUTES. Connect 2-pin driver-side air bag connector to cable reel connector. Install access panel under steering wheel.
- Connect 2-pin passenger air bag connector to SRS harness connector. Install glove box. Connect driver and passenger side impact air bag module 2-pin connectors under seats.
- Ensure ignition is off. Connect negative battery cable. Ensure air bag system is functioning properly. See SYSTEM OPERATION CHECK . Reset radio anti-theft code and preset radio frequencies.