LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2001 >> XL-7 Limited >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.7L V6 >> Repair Instructions >> Valves & Cylinder Heads Removal & Installation >> Removal

Valves & Cylinder Heads Removal & Installation: Removal

  1. Relieve fuel pressure according to FUEL PRESSURE RELIEF PROCEDURE .
  2. Disconnect negative (-) cable at battery.
  3. Drain engine oil.
  4. Drain coolant referring to COOLANT DRAINING .
  5. Remove CMP sensor, camshaft and valve lash adjuster. Refer to CAMSHAFT POSITION (CMP) SENSOR REMOVAL & INSTALLATION for CMP sensor removal and CAMSHAFTS & VALVE LASH ADJUSTERS REMOVAL & INSTALLATION  for camshaft and valve lash adjuster removal.
  6. Remove exhaust manifold referring to EXHAUST MANIFOLD REMOVAL & INSTALLATION .
  7. Remove water outlet cap.
  8. Loosen cylinder head bolts in such order ("1" "8") as shown in the figure and remove them.
    NOTE: Be sure to remove 2 hex bolts (1) shown in the figure.
    Fig 1: Loosening Cylinder Head Bolts In Order
    G02264002Courtesy of SUZUKI OF AMERICA CORP.
  9. Remove cylinder heads.
scientia non olet · About LEMON Manuals