Cylinder Head Covers Removal & Installation: Installation

Clean sealing surfaces on cylinder heads and covers.
Remove oil, old sealant, and dust from sealing surfaces. After cleaning, apply sealant "A" to cylinder heads sealing surface area as shown in the figure.
"A": Water tight sealant 99000-31250

Fig 1: Applying Sealant To Cylinder Heads Sealing Surface Area
Courtesy of SUZUKI OF AMERICA CORP.
Install new cylinder head cover gaskets (4) to head covers (1).
Install cylinder head covers (1) to cylinder heads.
Using new seal washers (3), tighten nuts (2) to specified torque.
Tightening torque

Cylinder head cover nut (a): 10.5 N.m (1.1 kg-m, 7.5 lb-ft)

Fig 2: Installing Cylinder Head Covers
Courtesy of SUZUKI OF AMERICA CORP.
Install ignition coils and connect ignition coil couplers referring to IGNITION COIL ASSEMBLY (IGNITER & IGNITION COIL) REMOVAL & INSTALLATION .
Install ignition coil covers.
Install intake manifold with throttle body. Refer to THROTTLE BODY & INTAKE MANIFOLD REMOVAL & INSTALLATION .