Grand Vitara, Vitara & XL7
- Disconnect rear wiper motor connector. Using jumper wire, connect 12-volt source to rear wiper motor connector terminal "D". See Fig 1
. Connect ground to Black lead at rear wiper motor connector. Rear wiper motor should operate at 35-45 RPM. Replace rear wiper motor if motor operation is not as specified. If wiper motor operation is as specified, go to next step.
- Using additional jumper wire, connect wiper motor connector terminals "A" and "D". See Fig 1
. Connect 12-volt source to terminal "C" at wiper motor connector. Motor should make one revolution and stop at park position. Repeat 2 more times. Replace rear wiper motor if motor does not stop at park position consistently.
Courtesy of SUBARU OF AMERICA, INC.