Centering Contact Coil Assembly
- If coil assembly has been removed from steering column and is being reinstalled, go to step 2). New coil assemblies are supplied pre-centered.
- Ensure front wheels face straight ahead when installing or removing a coil assembly. If coil is removed without wheels in straight-ahead position and steering wheel has not been moved, same coil can be reinstalled if coil hub also has not been rotated.
- If there is a possibility that coil has been moved, turn contact coil counterclockwise by hand until it reaches its stop. Turn contact coil clockwise 2 1/2 turns and align the marks. See Fig 1 .
NOTE:
New contact coil and combination switch assembly is supplied with contact coil set and held at its center position with lock pin and seal. Remove lock pin after installing contact coil and combination switch assembly to steering column.