LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 1992 >> Samurai JA >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.3L 4-CYL - VIN [3] & 1.6L 4-CYL - VIN [0] >> Removal & Installation >> Valves

Removal & Installation: Valves

  1. Remove carbon deposits. Inspect for wear, burns or distortion at face and stem. Replace as necessary. Measure valve head margin. Check valve stem end for pitting or wear.
  2. Measure valve length. Valve stem end may be resurfaced if no more than .14" (3.6 mm) is removed from valve length. See VALVES & VALVE SPRINGS  table under ENGINE SPECIFICATIONS. Using "V" block and dial gauge, check valve head radial runout. Maximum limit is .003 (.08 mm). If runout exceeds limit, replace valve.
scientia non olet · About LEMON Manuals