Fuel Pressure Release

Before beginning any work on fuel injection system or disconnecting any fuel lines, relieve fuel pressure. Place gear shift lever in NEUTRAL or PARK. Set parking brake.
On Swift, remove engine cooling reservoir from bracket and remove main fuse box cover. Remove main fuse box from body to access fuel pump relay connector. On all models, disconnect wire connector from fuel pump relay. See Fig 1 -Fig 3 .
Remove fuel cap from gas tank to allow pressure to equalize then reinstall cap. Start engine and idle until engine dies. Crank engine 2 or 3 times to ensure lines are empty. Reconnect fuel pump relay connector.

Fig 1: Locating Fuel Pump Relay (Samurai)

Courtesy of SUZUKI OF AMERICA CORP.

Fig 2: Locating Fuel Pump Relay (Sidekick)

Courtesy of SUZUKI OF AMERICA CORP.

Fig 3: Locating Fuel Pump Relay (Swift)

Courtesy of SUZUKI OF AMERICA CORP.