LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 1990 >> Swift GS, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.3L 4-CYL - VINS [3,5] & 1.6L 4-CYL - VIN [0] >> Removal & Installation >> Cylinder Head (Sidekick, Swift) >> Removal (Sidekick & Swift)

Removal (Sidekick & Swift)

  1. Release fuel pressure. See FUEL PRESSURE RELEASE  . Label and remove hoses, lines and electrical connectors for intake and exhaust manifold removal. Disconnect exhaust pipe from manifold.
  2. It is not necessary to remove exhaust and intake manifold at this time. Remove timing belt. See TIMING BELT. Discharge A/C system. Remove compressor suction hose from suction pipe (if equipped).
  3. Loosen cylinder head bolts in reverse order of tightening sequence. See Figure . Loosen head bolts in 2 or 3 steps to prevent cylinder head warpage. Remove bolts and cylinder head with intake and exhaust manifolds.
scientia non olet · About LEMON Manuals