Cylinder Block Specifications

CYLINDER BLOCK SPECIFICATIONS

Application

In. (mm)

Maximum Block Warp ⁽¹⁾

.006 (.15)

Cylinder Bore

Standard Diameter

1.3L ⁽²⁾

2.9138-2.9142 (74.01-74.02)

1.6L ⁽³⁾

2.9531-2.9535 (75.01-75.02)

Maximum Taper

.0039 (.100)

Maximum Out-of-Round

.0039 (.100)

⁽¹⁾	Surface may be machined a maximum of .008" (.20 mm) from original surface.

⁽²⁾	Cylinder block is stamped with cylinder bore diameter I.D. numbers. Specification is for I.D. No. 1. I.D. No. 2 is 2.9134-2.9138" (74.00-74.01 mm). See Text and Figure .

⁽³⁾	Cylinder block is stamped with cylinder bore diameter I.D. numbers. Specification is for I.D. No. 1. I.D. No. 2 is 2.9528-2.9531" (75.00-75.01 mm). See text and Figure .