Instrumentation System (Diagnostics)
- Basic Diagnostic Procedure
- Check List for Interview
- General Description
- Electrical Component Location
- Control Module I/O Signal
- Inspection Mode
- Diagnostic Procedure for Subaru Select Monitor Communication
- Data Monitor
- Freeze Frame Data
- Active Test
- Customize
- Diagnostic Trouble Code (DTC)
- Diagnostic Procedure with Diagnostic Trouble Code (DTC)
- DTC B1500: Fuel Sender Open Detected
- DTC B1501: Power Supply System Error Detection
- DTC B1502: Warning Box Communication Malfunction
- DTC B1503: Meter Control Module Can Register Stuck
- DTC B1507: Outside Temperature Sensor Open Detected
- DTC B1509: Cockpit Control Signal Input
- DTC U0074: Control Module Communication Bus "Body-Can" Off
- DTC U0100: Lost Communication With ECM/Pcm "A"
- DTC U0101: Lost Communication With TCM
- DTC U0122: Lost Communication With Vehicle Dynamics Control Module
- DTC U0127: Lost Communication With Tire Pressure Monitor Control Module And/Or Keyless Entry Control Module
- DTC U0128: Lost Communication With Park Brake Control Module
- DTC U0129: Lost Communication With Brake System Control Module
- DTC U0131: Lost Communication With Power Steering Control Module
- DTC U0141: Lost Communication With Body Control Module "A"
- DTC U0151: Lost Communication With Restraints Control Module
- DTC U0181: Lost Communication With Headlamp Leveling Control Module
- DTC U0327: Software Incompatibility With Vehicle Security Control Module
- DTC U1120: Lost Communication With AUTOSTART Stop Control Module
- DTC U1140: Lost Communication With Body Control Module Body-Can
- DTC U1232: Lost Communication With Rear/Side Radar Control Module
- DTC U123A: Lost Communication With Driver Monitoring System
- DTC U1283: Lost Communication With Eyesight SA-Bus
- DTC U143A: Invalid Data Received From Driver Monitoring System
- DTC U1533: Invalid Data Received From Rear/Side Radar Control Module
- DTC U1584: Invalid Data Received From Eyesight SA-Bus
- Diagnostics with Phenomenon
- List
- Inspection
- Si-Drive Mode Indication Does Not Change And Modes Do Not Switch After Switching Si-Drive Modes
- Si-Drive Mode Display Icon In The Combination Meter Blinks Approx. 5 Seconds After Switching Si-Drive Modes
- Si-Drive Mode Display Icon In The Combination Meter Blinks After Switching Si-Drive Modes
- Faster/Slower Vehicle Speed Than The Actual Speed Is Displayed
- More/Less Fuel Than The Actual Amount Is Displayed
- Fuel Level Warning Light Illuminates Despite Of Sufficient Fuel
- Engine Coolant Temperature Light Blinks In Red And Blue Alternately
- Door Indicator Is Not Displayed
- Clearance Indicator Does Not Illuminate
- Hi Beam Indicator Does Not Illuminate
- Front Fog Light Indicator Does Not Illuminate
- Illumination Is Fixed At The Maximum Brightness