Center Console: Removal
CAUTION:
Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION
.
- Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY
.NOTE:
- Release the shift lock and shift the select lever to the "N" position. Ref. to CONTROL SYSTEMS>SELECT LEVER>REMOVAL .
- On power seat models, move the front seat all the way forward before disconnecting the ground terminal from the battery sensor.
- Remove the cover assembly front and the console box assembly. Ref. to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>REMOVAL .
- Remove the right and left cover center sides.
- Disconnect the front antenna assembly interior connector. (Model with keyless access with push button start)
- Remove the harness clamp. (Model with rear seat heater)
- Remove the screws and release the clips, and pull the cover center side to remove.NOTE: Release the claws and clips on the RH side in the same procedure as on the LH side.
- Release the clips and detach the tray center LWR.