Each Impact Sensor

NOTE: The sensor shapes vary depending on the locations.

How to disconnect:
NOTE: When pulling the slide lock or disconnecting the connector, be sure to hold the connector, not the harness, to disconnect.
1. While pushing the lock arm (A), pull the outer part of connector one step in the direction of arrow.⁽¹⁾
2. While pressing down the lock arm (A), hold the outer part of connector to disconnect the connector.⁽²⁾
Courtesy of SUBARU OF AMERICA, INC.
How to connect:
NOTE: Be sure to insert the connector in until it is locked. Then pull it gently to make sure that it is locked.

Holding the connector, push it in securely until a clicking sound is heard.