DTC B225A: Center Information Display

DTC detecting condition  :

Detected when the center information display has an internal failure.

Trouble symptom  :

Display and operation of the center information display are faulty.

Failure detection pattern  :

• "Primary" (high-priority diagnosis)

1. CHECK DTC  .
   1. Turn the ignition switch to ON.
   2. Using the Subaru Select Monitor, perform the clear memory of [Cockpit Control]. Ref. to COMMON (DIAGNOSTICS)>CLEAR MEMORY .
   3. Turn the ignition switch OFF → ON.
   4. Read the DTC of [Cockpit Control] using the Subaru Select Monitor. Ref. to COCKPIT CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

   Is DTC B225A displayed? (Current code)

   Yes  : GO TO  2.

   No  : Even if DTC is displayed, the circuit has returned to a normal condition at this time.

   Reproduce the failure, and then perform the diagnosis again.

   NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2. CHECK CONNECTOR  .

   Check each connector connected to the center information display.

   Is the check result OK?

   Yes  : Replace the center information display. Ref. to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY SYSTEM .

   No  : Repair the harness or replace the components.