LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2024 >> Impreza Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System & Driver Information Center >> Combination Meter >> Installation

Combination Meter: Installation

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Install the combination meter assembly.
    1. Connect each connector.
    2. Install the combination meter assembly.
  2. Install the visor assembly.
  3. Install the cover steering UPR.
  4. Install the panel start switch. (Model with push button ignition starter) Ref. to SECURITY AND LOCKS>PUSH BUTTON IGNITION SWITCH>INSTALLATION .
  5. Install the cover start switch. (Model without push button ignition starter)
  6. Install the panel assembly center. Ref. to EXTERIOR/INTERIOR TRIM>CENTOR CLUSTER>INSTALLATION .
  7. Install the driver monitoring unit. (Model with driver monitoring system) US Ref. to INSTRUMENTATION/DRIVER INFO>DRIVER MONITORING UNIT>INSTALLATION .
  8. Install the light holder driver.
  9. Install the cover LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION .
  10. Install the ornament panel mid driver assembly. Ref. to AIR CONDITIONER>AIR VENT GRILLE>INSTALLATION>SIDE GRILLE .
  11. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  12. When the combination meter assembly was replaced, perform the variant work. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER>REPLACEMENT>VARIANT WORK .
  13. When the combination meter assembly has been replaced, read the [Combination Meter] customizing information. Ref. to COMBINATION METER (DIAGNOSTICS)>CUSTOMIZE .
scientia non olet · About LEMON Manuals