LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2024 >> Impreza Base >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System >> Spot Map Light >> Removal

Spot Map Light: Removal

NOTE: Do not remove the light assembly map if removing the bulb only.
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the cover assembly map light.
    1. Release the claw.
    2. Remove the cover assembly map light.
    G14612392Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the light assembly map.
    1. Remove the screws.
    2. Release the clips.
    3. Disconnect the connector.
    4. Remove the light assembly map.
    G14612393Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the map light bulb.
    CAUTION:
    • Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.
    • When using a flat tip screwdriver, use an appropriate sized tool for the insertion opening, apply protective tape or cloth around the tool, and be careful not to cause damage.
    NOTE: Perform this procedure only when required.
    1. Release the claw.
    2. Remove the lens.
    3. Remove the map light bulb.
    G14612394Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals