LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2024 >> Impreza Base >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control System (Diagnostics) >> Registration Body Integrated Unit >> Operation >> Confirm Current Setting

Confirm Current Setting

  1. On [Start] screen, select [Diagnosis].
  2. On [Vehicle selection] screen, input the target vehicle information and select [OK].
  3. On [Main Menu] screen, select [Each System].
  4. On [Select System] screen, select [Body Control], and then select [Enter].
  5. On [Select Function] screen, select [Customize].
  6. Save the setting.
    REQUIRED PARTS FOR NEW REGISTRATION (EXCEPT FOR SYSTEM NOT EQUIPPED)

    Item Contents Remarks
    Off delay time OFF 10 Sec 20 Sec 30s -
    Auto Light Sensitivity Adjustment Dull Normal Sensitive Very sensitive -
    Lane change signal setting Exist Not Exist -
    Rear wiper auto setting Exist Not Exist -
    Driver's Door Unlock Setting ALL Selection Option setting
    Rear Gate Unlock Setting Selection ALL -
    Wiper link Auto Light Setup ON OFF -
    Vehicle Automatic Door Lock OFF Vehicle Speed Select Lever P -
    Vehicle Automatic Door Unlock OFF Select Lever P Power OFF Driver Door Open -
    High Beam Assist Current Setting ON OFF Option setting
    Rr Defogger op. mode Normal Continuous -
    Security Alarm Setup ON OFF -
    Alarm delay setup ON OFF -
    Lockout prevention ON OFF -
    Buzzer sounding setting ON OFF Option setting
    Hazard answer-back setup ON OFF -
    Dome Light Alarm Setting ON OFF -
    wiperdeicer Exist Not Exist -
    Factory initial setting Factory Market Do not set to Factory mode.
    Sunroof setting Exist Not Exist -
    Welcome Light (Exit) OFF 30 seconds 60 seconds 90 seconds -
    Welcome Light Off Delay Time (Approaching) OFF 30 seconds 60 seconds 90 seconds -
    Keyless Buzzer Volume 1 2 3 4 5 6 7 Option setting
    Auto Dimmer Cancel Setting 0 (OFF) Least Less Normal More Most -
    Light LIN setting Exist Not Exist -