LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2023 >> WRX GT >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Exterior Lights (Diagnostics) >> Warning Light Illumination Pattern >> Warning Light Comes On >> SRH Warning Light Illuminates

SRH Warning Light Illuminates

CAUTION: Initialization is required after replacing the auto headlight beam leveler control module  . Ref. to LIGHTING SYSTEM>AUTO HEADLIGHT BEAM LEVELER SYSTEM>PROCEDURE .
  1. CHECK DTC  .

    Read the DTC of [Headlight/Foglight] using the Subaru Select Monitor. Ref. to HEADLIGHT/FOGLIGHT (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Are any DTCs displayed? (Current code)

    Yes:  Perform the diagnosis for the displayed DTCs. Ref. to HEADLIGHT/FOGLIGHT (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST .

    No:  Go to  2.

  2. CHECK DTC  .

    Read the DTC of [Combination Meter] using the Subaru Select Monitor. Ref. to COMBINATION METER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Are any DTCs displayed? (Current code)

    Yes:  Perform the diagnosis for the displayed DTCs. Ref. to COMBINATION METER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST .

    No:  Go to  3.

  3. CHECK FOR POOR CONTACT  .

    Check the auto headlight beam leveler control module and combination meter connectors for poor contact (half engagement, etc.).

    Is the check result OK?

    Yes:  The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

    NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

    No:  Repair the poor contact of connector, and check that the problem is resolved. If the problem is resolved, it is possible that temporary poor contact occurred.

scientia non olet · About LEMON Manuals