Related Lines, More Than 52 Ω And Less Than 62 Ω (Body Can_Power Rear Gate)

Wiring diagram: 

CAN communication system Ref. to WIRING SYSTEM>CAN COMMUNICATION SYSTEM>WIRING DIAGRAM .

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK BETWEEN RELATED LINES AND MAIN WIRING HARNESS  .
   1. Disconnect the power rear gate Control Module connector.
   2. Using a tester, measure the resistance between power rear gate Control Module connector terminals.

      Connector & terminal 

      (L84) No. 2 - (L84) No. 10:

   Is the resistance 400 Ω or more?

   Yes:  A related line between power rear gate Control Module and main wiring harness is open, or main wiring harness is open at two places or more.

   No:  Go to  2.

2. CHECK RELATED LINES  .

   Using a tester, measure the resistance between power rear gate Control Module connector and central gateway Control Module connector.

   Connector & terminal 

   (L84) No. 2 - (i88) No. 6:

   (L84) No. 10 - (i88) No. 5:

   Is the resistance 10 Ω or more?

   Yes:  Repair or replace the open circuit of power rear gate related lines.

   No:  Check DTC of power rear gate system. Ref. to POWER REAR GATE (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .