RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω ((H) ADVANCED SAFETY CAN_EyeSight ASSIST MONITOR)

Wiring diagram:

CAN communication system Ref. to WIRING SYSTEM>CAN COMMUNICATION SYSTEM>WIRING DIAGRAM .

Courtesy of SUBARU OF AMERICA, INC.

NOTE: When the measured resistance value is more than 52 Ω and less than 62 Ω, main wiring harness or related lines may be shorted to ground, or shorted to power supply line, or related lines may be open.

CHECK BETWEEN RELATED LINES AND MAIN WIRING HARNESS .
1. Disconnect the EyeSight assist monitor connector.
2. Using a tester, measure the resistance between terminals in EyeSight assist monitor connector.
  Connector & terminal
  
  (i86) No. 4 - (i86) No. 5:
Is the resistance 400 Ω or more?

Yes: Related lines between EyeSight assist monitor and main wiring harness is open, or main wiring harness is open at two places or more.

No: Go to 2.
CHECK RELATED LINES .
1. Disconnect the central gateway Control Module connector.
2. Using a tester, measure the resistance between EyeSight assist monitor connector and central gateway Control Module connector.
  Connector & terminal
  
  (i86) No. 4 - (i88) No. 34:
  
  (i86) No. 5 - (i88) No. 33:
Is the resistance 10 Ω or more?

Yes: Repair or replace the open circuit of EyeSight assist monitor related lines.

No: Check DTC of EyeSight assist monitor. Ref. to EYESIGHT ASSIST MONITOR (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .