Lane Departure Warning Off Indicator Light Does Not Go Off/Lane Departure Warning Off Indicator Light Illuminates Automatically
- CHECK CONDITION OF OCCURRENCE
.
Interview the customer to check if it occurs when the engine is started.
Does it occur when starting the engine?
Yes : This is normal. (Light illumination for a while after the engine start is normal.)
No : Go to 2.
- CHECK DATA MONITOR
.
- Using the Subaru Select Monitor, check the following items in the [Data Monitor] of [EyeSight]. Ref. to EYESIGHT (DIAGNOSTICS)>DATA MONITOR .
- Lane Departure Warning Function
- Perform the ON/OFF switching operation on "Lane departure warning" setting screen of the center information display.
Do the ON/OFF switching operation and the [Data Monitor] indication match?
Yes : Go to 3.
No : Perform the inspection according to the diagnosis for cockpit control system. Ref. to COCKPIT CONTROL (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .
- Using the Subaru Select Monitor, check the following items in the [Data Monitor] of [EyeSight]. Ref. to EYESIGHT (DIAGNOSTICS)>DATA MONITOR .
- CHECK DATA MONITOR
.
- Using the Subaru Select Monitor, check the following items in the [Data Monitor] of [EyeSight]. Ref. to EYESIGHT (DIAGNOSTICS)>DATA MONITOR .
- Lane Departure Warning Display Signal
- Lane Departure Warning Function
- Perform the ON/OFF switching operation on "Lane departure warning" setting screen of the center information display.
Is the indication of [Data Monitor] as shown below?
When set to OFF on "Lane departure warning" setting screen: [Lane Departure Warning OFF Indicator] is set to [Yes], and [Lane Departure Warning Function] is set to [OFF]
When set to ON on "Lane departure warning" setting screen: [Lane Departure Warning OFF Indicator] is set to [No], and [Lane Departure Warning Function] is set to [ON]
Yes : Go to 4.
No : Replace the stereo camera. Ref. to EYESIGHT>STEREO CAMERA>REMOVAL .
- Using the Subaru Select Monitor, check the following items in the [Data Monitor] of [EyeSight]. Ref. to EYESIGHT (DIAGNOSTICS)>DATA MONITOR .
- CHECK COMBINATION METER
.
Perform the ON/OFF switching operation of the lane departure warning of the center information display.
Is the lane departure warning OFF indicator light of the combination meter as follows?
When the function is OFF: Illuminate
When the function is ON: Go off
Yes : Currently, it is normal. Finish the diagnosis.
No : Perform the inspection according to the diagnosis for combination meter. Ref. to COMBINATION METER (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .