Clearance Adjustment
- Loosen the lock nut, and adjust the stop light switch assembly position until the clearance A between the threaded end of the stop light switch assembly and stopper becomes 1.5 mm (0.06 in). Then, tighten the lock nut A so that the stop light switch assembly position is not displaced.
Tightening torque:
8 N.m (0.8 kgf-m, 5.9 ft-lb)
| (a) | Stop light switch ASSY |
| (b) | Lock nut A |
| (c) | Lock nut B |
| (d) | Stopper |
| (e) | Brake pedal |