Main Shaft: Adjustment
Selection of main shaft rear plate:
Measure the protrusion amount (A) of double taper roller bearing from transmission main case surface, and select a suitable plate in the following table.
NOTE:
Before measuring, tap the end of main shaft with a plastic hammer lightly in order to make the clearance zero between the main case surface and moving flange of bearing.
| Dimension (A) mm (in) |
Part No. | Mark |
|---|---|---|
| 4.00 - 4.13 (0.1575 - 0.1626) |
32294AA041 | 1 |
| 3.87 - 4.00 (0.1524 - 0.1575) |
32294AA051 | 2 |